6-8
6. DIAG. TEST OPERATION
EO18-33007
6.2.2 Automatic Diagnostic Printing
The data from
1
to
0
on a sample print is printed.
6.2 SELF TEST MODE
NOTES:
1. If the automatic diagnosis printing results in an error, the printer will display the error
message and stop printing. The error status can be cleared by the [PAUSE] key,
however, the display will return to the initial display "<1> DIAG. V1.0A". Printing is not
automatically resumed.
2. Both label and tag paper can be used for printing.
Power off
Press the [PAUSE] key.
Press the [PAUSE] key.
Press the [PAUSE] key.
Select the ribbon type from those
at the right by pressing the
[FEED] key or [RESTART] key.
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1
D I A G N
I C V
>
R I
B O N
T R A N S M
B
The result of the self test
is printed. After printing,
the initial display will be
shown.
NO RIBBON (No ribbon : Thermal direct)
NO TRANS.
TRANSMISSIVE
(Transmissive ribbon : Thermal transfer)
(Non-transmissive ribbon : Thermal transfer)
The printer is checking or printing
the status
I
I
S S
V E
1 . 0 A
O S T
A U
O M A T I
I A G N O
T
S T I C
C D
C H
C K I N G
P R I N T
E
I N G
&
Summary of Contents for B-880 series
