Chapter 2 Printer Installation
12
6
Turn the Supply Shaft so that the notches face upward, and the
marks face the Media Inlet.
7
To attach the Supply Roll Holder (inside), fit the tooth of the
Supply Roll Holder to the groove of the Supply Roll Shaft. Turn
the Supply Roll Holder clockwise to the end.
Supply Roll Holder
Claw
Tooth
Claw
Supply Shaft
Marks
Notches
Supply Roll Holder
CAUTION!
Do not push into the Supply
Roll Holder (inside) with the
claw locked in the notches, as
this may cause damage to the
claw or notches.
See Section 2.5.1 for more
detail.
8
Push the Supply Roll Holder (inside) to the end of the Supply
Shaft. Then turn the Supply Roll Holder counterclockwise so
that the claw is locked into the notch. When inserting the Supply
Roll Holder into the Supply Shaft, more pressure should be applied
when passing over the roller on the way to the end of the Supply
Shaft.
Claw
Notches
Marks
9
Switch the Back Tension Selector, depending on whether the media
is rolled outside or inside. Switch the Selector to A for the media
rolled outside. Switch it to B for the media rolled inside, as
indicated by the arrows.
Note:
The media is rolled either outside or
inside, depending on the type of media
that is loaded. Whichever media is
used, load it with print side facing up.
See Appendix 1 for more detail.
Supply Shaft Holder
Back Tension Selector
A
B
Media rolled outside
Media rolled inside
10
Measure width of the media that will be loaded.
Groove
2.5
Loading the
Media (Cont.)
Summary of Contents for CB-426-T3-QQ
Page 1: ...TEC Two Color Printer CB 426 T3 QQ Owner s Manual ...
Page 121: ......
Page 122: ...PRINTED IN JAPAN EO1 33027 E ...
