6. LSServer, Scanner Shell and Download
2004-11
Operating Manual for the LS Series Scanner No. 30001798 Rev. No. 1.5
6-15
Autofocus Area option button
Select the
Autofocus Area
option button to enable the
Autofocus Settings group box.
Set the Autofocus lines by adjusting the boundaries of the rectangular AOI. To
adjust a boundary, place the cursor along the edge or corner of the AOI and drag
it when the 2-way cursor appears. To move the AOI, place the cursor in the
middle of the rectangle and drag it when the 4-way cursor appears. Click
Apply
to confirm the newly defined areas. If HS or Wellmode Autofocus has been
chosen, a green check mark appears and the Autofocus area is centered
automatically to the scan area.
figure 6-2
Minimum distance between Autofocus lines: 3mm x 3mm.
Legend:
barcode line
autofocus lines
scan area
AGC area
