3
Connecting the Fixture
Connect the fixture on the hard wires (refer to the
instructions provided with the fixture).
NOTE: Make sure the fixture connections are
tight. Avoid connecting heavy fixtures to the
Kable Lite canopy hard wires.
#4-40 SCREW
120 VOLT POWER LINE WIRES
120 VOLT
TRANSFORMER
WIRES
DOME COVER
#8-32 ROUND
HEAD SCREW
BACK PLATE
CEILING
ELECTRICAL
BOX
Installing the Surface Canopy
Turn the power to the electrical box off.
Remove the #4-40 screws on canopy sides to remove
the surface dome cover from the backplate.
Mount the backplate of the surface mount canopy to the
electrical box with the two #8-32 round head screws.
Connect the transformer 120 volt wires to the proper
120 volt power line wires with wire nuts.
Place all wires and wire nut connections into the
electrical box.
Replace the dome cover onto the backplate. Replace and
tighten the two #4-40 screws.
#4-40 SET SCREW
0.05 ALLEN WRENCH
5A
1
2
3
4
5
6
2
3
3
4
4
6
6A
1
1
