42
Thanks to this programming system, you no longer need to tediously enter the date, programme number, start
and end time. All the information needed by the DVD RVCR for programming is contained in the
ShowView programming number. This ShowView number is found in most TV listings.
1
Insert recordable media such as DVD±R ,DVD±RW, recordable VHS tape.
2
Press [TIMER].
or
Press [SETUP] and select ‘Timer REC’. Then press [ENTER].
The ‘Timer Recording’ menu appears.
3
Select ‘ShowView’ with [
…
/
†
] and confirm with [ENTER].
The ‘ShowView’ menu appears.
Enter the entire ‘ShowView’ number. This number is up to 9 digits long and
can be found next to the start time of the TV programme in your TV listings
magazine.
e.g.: 5-234-89 or 5 234 89
Enter 523489 for the ‘ShowView’ number.
4
Press [ENTER] to confirm.
5
The decoded information appears after confirmation. You can change the
information by selecting the appropriate input field using [
…†
]. If
required, change the information using [
…†
].
If all the information is correct, press the [ENTER] button. The programming
information is stored in a TIMER block.
6
Press [SETUP] to exit the Timer Record List.
7
Timer indicator will light or blink. You must power off the DVD RVCR
to start the Timer Recording.
Timer Recording using ShowView system
• ShowView is not available in some countries.
• ShowView is a trademark applied for by Gemstar Development Corp.
The ShowView system is manufactured under license from Gemstar
Development Corporation.
Timer Recording
01/01 00:13:23
Timer Recording
01/01 00:13:23
Input Digits
Confirm
Exit
SETUP
0-9
ENTER
PR No
Date
Start
Stop
Repeat
PR 1
16 / 1
11 : 00
12 : 00
Once
Sun
Media
Title
Mode
DVD
TITLE PR 4
SP
…
†
Code
1111
Media
DVD
Mode
SP
Repeat
Once
Input Digits
Confirm
Exit
SETUP
0-9
ENTER
Timer Recording
01/01 00:13:23
PR No
Date
Start
Stop
Media
Repeat
Mode
PR01
16/1
11:02
12:00
DVD
Once
SP
New Input
Delete
Edit
Exit
Prev Page
Next Page
§
■
∞
ENTER
TIMER
Timer Recording
Move
Confirm
Manual
ShowView
ENTER
…†
Timer Recording
• The Timer indicator lights on the front panel display when the DVD RVCR is ready for the Timer
Recording.
• The DVD RVCR will automatically power off when the Timer Recording ends.
• There is a short delay when a timer recording finishes to confirm the recorded program. If two timer recordings
are set to record sequentially (one right after the other), the very beginning of the later program may not be
recorded.
DF-T3712S-SA-W(GB) 2006.9.13 10:0 AM ˘
` 42 mac001 1200DPI 90LPI
