background image

Page 

2

 of 

4

 

Controls and Indicators: 

 

Front, Vertical Face: 
Power Indicator

, Green when Operating Normally 

Microphone Input Level Indicator/VOX Indicator:  

Off (VOX not tripped), microphone off ; Red, Low audio Level ; Flashing Green; Normal audio level 

Headset On Indicator: 

Green when the Operator Wireless Headset is ON;  

When the Headset is ON, the Console Microphone, Speaker, and Switches, are disabled 
 

Sloped Face: 
LISTEN Switch

 (Toggle Action) 

Remote Station Selected Indicator:  

Red when selected - 

Controls both the Listening and Talking to the Remote Station 

Console TALK Switch

 (Toggle Action with VOX, or Momentary when Push-to-Talk) 

TALK Indicator:

  

Red when Microphone is enabled - 

Allows listening without interrupting the Remote Conversation 

 

Side: 
Console Speaker Listening Level

 (Knob Pot, Side) 

The Console Speaker Level Adjustment is limited, the speaker may not be turned completely off

 

 
Rear Connections: 

 

 

CI-BUSS, “Master” Connector, 

RJ-45, 

Footswitch

 (Optional), 1/4" TRS Jack  - 

Used for 'Push-to-Talk' Operation 

Power Connector: 

3.5mm Barrel Connectors - 

24Volts, 1 Amps Maximum 

Chassis,  Earth  Ground:  Hex  Nut,  the  Chassis  is  connected  to  Circuit  Common  through  a  1-Meg-Ohm 
resistor 

 
Side Connections: 
Headset Connector

, RJ-22, CS-540, Plantronics, Wireless Headset (Optional) 

 

The CS-540 requires initial adjustments 

Configuration Switch:  “A” 
Earphone Switch: 

“4” 

Microphone Switch: 

“6”  

CI-BUSS

MASTER

FOOT

SWITCH

POWER

24VDC

300mA

Tech Works

CI-ODC-1

Summary of Contents for CI-ODC-1

Page 1: ...aker Buttons and indicators provide control to allow the operator to just listen to the CI Buss communication or to talk and collaborate hands free A headset jack on the side of the console allows connection of a local operator headset such as the CS 540 wireless unit Basic Operator Console Block Diagram Isolation Transformers not shown for simplicity The CI BUSS interface allows connection of add...

Page 2: ...when Push to Talk TALK Indicator Red when Microphone is enabled Allows listening without interrupting the Remote Conversation Side Console Speaker Listening Level Knob Pot Side The Console Speaker Level Adjustment is limited the speaker may not be turned completely off Rear Connections CI BUSS Master Connector RJ 45 Footswitch Optional 1 4 TRS Jack Used for Push to Talk Operation Power Connector 3...

Page 3: ... off to indicate the Console Microphone is disabled When the TALK switch is pushed again the indicator lights red to indicate the Microphone is enabled When the microphone is enabled the Switchover is Voice Activated VOX The Operator must speak directly into the Console Microphone At a distance of 6 for proper response The LIMIT VOX indicator lights Green to indicate the VOX is tripped During norm...

Page 4: ...he Wireless Headset has an ON OFF switch when the Headset is Off the function is the same as above The Headset has priority and converses with the Procedure Room when the HEADSET ON indicator is lighted Red The Console Microphone Speaker and Switches are disabled The Listen and Talk indicators are forced off Configuration Jumpers Console Cover Removed Jumper As Shipped Jumpers to the Right Move bo...

Reviews: