TECH
13
13.
BUTTON LOCK
The LOC function is used to lock the buttons. It may be enabled (ON) or disabled (OFF) with the use of PLUS/MINUS
buttons. The lock is activated after the main screen blanking. Hold the PLUS and MINUS buttons for about 3 seconds to
deactivate the lock.
VII.
REGULATOR FUNCTIONS – MENU 2
In order to move to the second menu, hold the MENU button for about 5 seconds. Press the button to view the regulator
options.
1.
REGISTRATION
In order to ensure proper communication between the regulator and the main controller, it is necessary to register the
regulator.
NOTE
To register the regulator, your main controller software version must be at least 1.3.4 or later. In the case of
older versions, the main controller software must be updated.
1.
Go to the fitter’s menu in the main controller, find the valve and select regulator function and registration.
2.
Press and hold the MENU button in the regulator to select REG function (registration).
3.
Hold the PLUS and MINUS buttons at the same time to start the registration. If the registration has been
completed successfully, the display will show the message: ScS.
NOTE
The first step in registering the regulator is to start the registration process in the main controller and next select
registration option in the room regulator.
After successful registration, wait 30 seconds before registering another regulator.
2.
BUILT-IN SENSOR CALIBRATION
Calibration should be performed while mounting or after it has been used for a long time, if the room temperature
measured by the sensor differs from the actual temperature. Calibration setting range is from -9,9 to +9,9 ⁰C with the
accuracy of 0,1⁰C.
To calibrate the built-in sensor, hold the MENU button to enter the second Menu. Next, keep pressing the MENU button
until the temperature sensor calibration screen appears (CAL). Use the PLUS or MINUS buttons to set the desired
correction. To confirm, press the MENU button (confirm and go on to edit the next parameter) or the EXIT button (confirm
and return to the main screen view). The changes will also be saved automatically after about 5 seconds of inactivity.
3.
FLOOR SENSOR CALIBRATION
Floor sensor calibration (an additional icon is displayed:
) should be performed if the floor temperature measured by
the sensor differs from the actual temperature. Calibration setting range is from -9,9 to +9,9 ⁰C with the accuracy of 0,1⁰C.
To calibrate the built-in sensor, hold the MENU button to enter the second Menu. Next, keep pressing the MENU button
until the floor sensor calibration screen appears (CAL
). Use the PLUS or MINUS buttons to set the desired correction.
To confirm, press the MENU button (confirm and go on to edit the next parameter) or the EXIT button (confirm and return
to the main screen view). The changes will also be saved automatically after about 5 seconds of inactivity.
Summary of Contents for EU-RI-1
Page 1: ...TECH 1 EU RI 1 ...
Page 16: ...TECH 16 ...
