ST-37 –
Instruction Manual
room setpoint temperature has been reached, the central heating pump is
shut off and will be activated again when the room temperature drops below
the setpoint value). However, the boiler is limited in its operation by the
temperature set with the boiler controller. When the
room regulator
function
is enabled, the display shows the lower-case letter
p
.
CONNECTING THE ROOM REGULATOR:
the room regulator has a two-wire
cable that should be connected to the controller's connection strip, via a
connector marked as
room regulator
.
ATTENTION:
no external voltage can be applied to the room regulator
output.
II.o) Week-Based Regulation
With this function, you can program daily temperature changes in the boiler.
Step one:
First set the correct time and date.
Step two:
Set the days (parameters used in the first mode):
- 14 -
22
o
c 56
o
c
C.H. ON
Room Reg
Week-based Reg
Time
Date
Summary of Contents for ST-37
Page 1: ......
Page 24: ...ST 37 Instruction Manual 24...
