ST-37 –
Instruction Manual
With this function, you can set the blow interval in the sustain mode.
The two menus are used for regulating the furnace while in the
sustain
mode. This is to prevent damping of the furnace when the boiler temperature
is over the
setpoint value
.
ATTENTION
:
Incorrect settings may cause a continuous increase of the
temperature! In particular,
interval in the sustain
mode should not be too
short, and
operation in the sustain
mode should not be too long.
II.g) Feeder
With this function, you can disable or enable the fuel feeder, depending on its
condition (e.g. in order to damp the boiler).
II.h) Blow
With this function, you can disable or enable the blow, depending on its
condition (e.g. in order to damp the boiler).
- 8 -
22
o
c 56
o
c
C.H. ON
Fan Sustain Pause
Feeder
On *
Off
22
o
c 56
o
c
C.H. ON
Feeder
Blow
On *
Off
Summary of Contents for ST-37
Page 1: ......
Page 24: ...ST 37 Instruction Manual 24...
