TECH
III.1.Factory Settings
The regulator has been pre-configured. However, it should be adjusted to
your individual needs. It is possible to return to the factory settings at
any time. By enabling factory settings, all boiler settings that you have
made will be replaced by settings made by the manufacturer. From then
on, you can again set your own operating parameters for the boiler.
III.2.Valves 1 and 2
With this function, you can set the operation time for the mixing (three-
or four-way) valve only with modules ST-61. For the valve to operate
properly and as required, it is necessary to set several parameters.
III.2.a)
Registration
In this function, the fitter enters the serial number of the control module
used with the three-way valve actuator (
ST-61
, five-digit number
provided on the module housing). Without entering the number, the
function will be disabled.
-13-
FITTER’S MENU
Exit
Factory Settings
Valve 1
Valve 2
VALVE
Exit
Registration
Temp Monitor
Opening Time
FITTER’S MENU
Exit
Factory Settings
Valve 1
Valve 2
