ST-45 User's Manual
With this function, you can switch on and off the hot consumption water
pump in the summer mode, i.e. specify whether the hot consumption
water pump is to run after the preset temperature has been reached or it
is to be shut off. If you
enable
the function, the hot consumption water
pump will run permanently in the summer mode, whereas if you
disable
it, the pump will be shut off after the preset temperature has been
reached and activated again, depending on the boiler hysteresis applied.
IV.7.C.H. Pump Room Regulator
With this function, you can switch on or off the central heating pump
when the room regulator is active, i.e. you can decide whether the
central heating pump is to be shut off after the desired room temperature
has been reached.
B)
Reed Relay Protection
With this function, you can set the duration of a complete feed cycle. If
the cycle is not completed within the set period, the following message is
displayed:
Clean Feeder
. In this function, data are obtained form the Hall
sensor that is located at the feeder.
V.Stand-by Mode
-22-
SERVICE MENU
Exit
C.H. Pump Room Reg.
C.H. PUMP ROOM REG.
Exit
On
Off
MENU
Exit
Service Menu
Stand-by Mode
