background image

TJ325LP 

rev. 01/23/17

WARNING: Indicates a hazardous 
situation which, if not avoided, could 
result in death or serious injury.

IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING

BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING 
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.

It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility 
of the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product 
labels are lost or not legible, contact Tech for a free replacement. If the operator is not fluent in English, the product and safety 
instructions shall be read to and discussed with the operator in the operator’s native language by the purchaser/owner or his 
designee, making sure that the operator comprehends its contents.

THE NATURE OF HAZARDOUS SITUATIONS

The use of Portable Automotive Lifting Devices are subject to certain hazards that cannot be prevented by mechanical means, but 
only by the exercise of intelligence, care, and common sense. It is essential to have personnel involved in the use and operation 
of the device who are careful, competent, trained, and qualified in the safe operation of the device and its proper use when 
servicing motor vehicles and their components. Examples of hazards are dropping, tipping or slipping of loads caused primarily 
by improperly securing loads, overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a 
purpose for which it was not intended.

METHODS TO AVOID HAZARDOUS SITUATIONS

 

•  Read, study, understand and follow all instructions before operating this device.

 

•  Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition, leaking hydraulic fluid, 

or unstable due to loose or missing components. Make corrections before using.

 

•  Lift only on areas of the vehicle as specified by the vehicle manufacturer.

 

•  User and bystanders must wear eye protection.

 

•  Do not use jack beyond its rated capacity. Do not shock load.

 • 

This is a lifting device only. Immediately after lifting, support the vehicle with jack stands 
capable of sustaining the load before working on the vehicle.

 

•  Use only on a hard level surface free from obstructions so the jack is free to reposition itself during lifting and lowering 

operations.

 

•  Center load on saddle. Be sure setup is stable before working on vehicle.

 

•  Do not move or dolly the vehicle while on the jack.

 

•  Do not use any materials that may serve as risers, spacers or extenders between the stock lifting saddle and the load.

 

•  Do not use any adaptors that replace the stock lifting saddle unless approved or supplied by the jack manufacturer.

 

•  Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the 

manufacturer's authorized representative.

 

•  Always lower the jack slowly and carefully.

 

•   This product may contain one or more chemicals known to the State of California to cause cancer and birth defects or 

other reproductive harm. 

Wash hands thoroughly after handling

 

•   Failure to heed these warnings may result in fatal personal injury and/or property damage.

CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS

Failure to read this manual completely and thoroughly, understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS, 
MAINTENANCE INSTRUCTIONS and not comply with them, and neglecting the METHODS TO AVOID HAZARDOUS SITUATIONS 
could cause accidents resulting in serious or fatal personal injury and/or property damage.

WARNING

WARNING

This is the safety alert symbol. It is used to alert you 
to potential personal injury hazards. Obey all safety 
messages that follow this symbol to avoid possible 
injury or death.

WARNING

WARNING

WARNING

TJ325LP

3.25 TON CAPACITY 

FLOOR JACK

Summary of Contents for TJ325LP














Reviews: