TJ325LP
4
rev. 01/23/17
HYDRAULIC MAINTENANCE GUIDE
IMPORTANT: Service jacks are designed for lifting purposes only; always support raised load with jack stands.
REGULAR MAINTENANCE
MONTHLY
or as necessary (depending on usage)
#1 Using a grease gun, add grease to grease fitting in the lift arm pivot shaft.
(Use a multi-purpose NLGI type grease only.)
#2 Lubricate all linkages and pivot points.
(Use white lithium spray grease only.)
#3 Remove handle; lubricate handle receptacle and handle end.
(Use white lithium spray grease only.)
#4 Lubricate both rear casters bearings and both front wheels.
(Use white lithium spray grease only.)
Tighten all accessible hardware.
#2
#3
#4
#4
#4
#1
#2
#2
#2
#3
SPECIFICATIONS
Capacity ........................................................................ 3.25 Ton
Low Height ....................................................................... 3.74 in
High Height ....................................................................... 21.5 in
Pump Strokes to Load ............................................................... 8
Chassis Length ................................................................. 27.5 in
Low Height Reach ............................................................. 12.5 in
Overall Width ....................................................................... 14 in
Chassis Height ................................................................... 6.3 in
Handle Length ..................................................................... 50 in
Saddle Diameter ................................................................ 4.6 in
Net Weight .......................................................................94.8 Lb
Gross Weight ..................................................................103.6 Lb
