TS8200D Series
Micro-Meter Mix Quick Start Guide
2.
Unlock the unit by clicking lock icon. Default password = 0000
3.
Select the Purge Pump 2 icon.
4.
Press the foot switch.
5.
Allow the fluid to flow from the manifold until a steady stream of air-free
material is observed.
6.
Release the foot switch.
7.
We are now done purging Pump 2.
To vent the hardener:
8.
Have a cleaning towel or container under the pump ready to
catch material.
9.
Using a Phillips head screwdriver loosen front vent screw by turning in the
counterclockwise direction. Loosen screw in 1 revolution increments. At
around the 6
th
–
7
th
revolution you should begin to see material seep out. Allow
material to escape until no more air bubbles
are observed.
Warning:
Do not turn more than eight (8) complete revolutions. Doing so will
unfasten the screw allowing pressurized material to spray out.
10.
Fasten the venting screw. Avoid over tightening the screw. Over tightening
may lead to tearing of the vent seal O-ring.
6
