Caulk around the power line/cord where it enters the
cord grip with waterproof construction sealant.
10
3D
Carefully place the power line/cord inside the fixture,
install the fixture onto the base plate, and secure it in
place by tightening down the set screws.
11
3E
ALLEN
WRENCH
11
SET SCREW
6
3C
CONNECTION
BOX COVER
DOME NUT
CORD GRIP
CONNECTION
BOX COVER
SCREW
POWER WIRES/
CORD
9
8
7
6
Feed the previously installed power wires / cord through
the cord grip and dome nut, then screw the dome nut
tightly onto the cord grip.
Connect the white driver wire to one of the low-voltage
power line wire with a wire nut.
Connect the black fixture wire to the remaining low-
voltage power line with a wire nut.
Carefully place all wires and wire nut connections into
the connection box and reinstall the cover (reversal of
step 3).
7
8
9
3
11
