MULTIPLE DESKTOP MONITOR ARM WITH CLAMP
MULTIPLE DESKTOP MONITOR ARM WITH CLAMP
33
www.techly.com
HDMI oVER IP WITH PoE TRAnsMITTER/REcEIVER
HDMI oVER IP WITH PoE TRAnsMITTER/REcEIVER
3-Choosing/Arranging the Output Devices:
Here you can choose the devices you would like to use as input sources. If you have multiple input sources, you can set
which input sources you would like to use. Also, you can set how the input source will be display among single/multiple
monitors.
You can also view all HDMI over IP with PoE Transceivers located in the network here as well. Information listed here
includes their IP addresses and Host Name. To perform a network search, please press the
Search Device
button.
If you would like to access to each different HDMI over IP with PoE Transceiver, you will have to use the IP address
listed here.
To add a new input source, please choose the input source you would like to use, choose the number of monitors you
would like to use vertically/horizontally, and press the
“Add New View Source”
button as shown in the figure above.
You can also enable the
Tearing Delay
and
Show OSD
functions here.
•
Tearing Delay:
If the network environment is not stable,
video noises might occur on the TV wall.
Enabling this function will reduce the video delays
caused by unstable network environments.
•
Show OSD:
Addition information (serial number)
will be displayed on the monitor.
Press the
“Next>”
button when you’re done. To go back to
the previous setting page, press the
“Back”
button.