TM Palletizing Operator User’s Manual
Product Version: 1.1 Document Version: 1.2
151
Figure 120: Select Step 2
5.
In TMvision Task Designer:
A.
If the initial position is taught and guided beforehand, press and hold the
+
button on the teach pendant until the robot reaches the initial position.
i.
Put the box properly and place TM Landmark on the lower left
corner of the box.
ii.
Make sure TM Landmark is in the sight of the camera. This
position is suitable to take as the initial point in the meantime
when picking up the box.
B.
If using for the first time without the initial position being taught and guided
beforehand, click
Cancel
and proceed to teach and guide to the initial
position.
i.
Put the box properly and place TM Landmark on the lower left
corner of the box.
ii.
Hand guide the robot to the initial position for picking up the box
everytime, and make sure TM Landmark is in the sight of the
camera.
iii.
After the position is set, click
Initiate
to set the initial position, and
click
Reset Initial Position
to take the position as the initial
position.
Summary of Contents for TM Palletizing Operator
Page 40: ...TM Palletizing Operator User s Manual Product Version 1 1 Document Version 1 2 40 ...
Page 182: ...TM Palletizing Operator User s Manual Product Version 1 1 Document Version 1 2 182 ...
Page 183: ...TM Palletizing Operator User s Manual Product Version 1 1 Document Version 1 2 183 ...
Page 185: ...TM Palletizing Operator User s Manual Product Version 1 1 Document Version 1 2 185 ...
