Techmar 3194011, Manual

7

SMART

EN

The Garden Lights Arcus Plus is a smart light, for 

use in combination with the Garden Lights 12-volt 

outdoor lighting. To operate the smart lights, the (free) 

Garden Lights app should be installed on a suitable 

smartphone or tablet. For more information on how to 

download and use the app, go to  

www.garden-lights.com/en/smart.

[!] Make sure all parts are included in the packaging. 

You can always contact us with any questions you may 

have about parts or service, as well as complaints or 

other matters. Email: info@garden-lights.com.

Use

When installing the Arcus Plus, keep in mind the 

following regulations:

1  The Arcus Plus must be connected to a 12-volt 

Garden Lights system with a permanent voltage 

supply.

2  The Arcus Plus cannot be used in combination with 

the following accessories:

•  Motion Sensor (art.nr. 6156011)

•  Receiver (art.nr. 6148011 and 6149011)

3  When placing the smart lamps, consider the 

distance to the smartphone. The lamps have a 

good connection up to 16 meters. If the distance 

increases, the signal slows down.

4  The smart lights amplify the Bluetooth signal to 

each other. For proper operation, place the light up 

to a maximum distance of 20 meters from each 

other.

5  The Arcus Plus cannot be placed behind a 

Switch Plus (art.nr. 6269011) because it must be 

continuously supplied  

with power.

Restore factory settings

In the event of a malfunction, or if you have forgotten 

your password (set via the app), the Focus Plus can 

be reset to factory settings. To do this, proceed as 

follows:

[!] Warning: This will reset all Garden Lights Plus lights 

in your system to factory settings. Disconnect any 

lights whose settings you want to keep from the main 

cable before starting!

1  Make sure the system is supplied with power.

2  Leave the lights on for a minimum of 15 to a 

maximum of 20 seconds.

3  Disconnect the power from the system (e.g. by 

removing the plug of the lamp from the cable).

4  Wait a minimum of 5 to a maximum of 10 seconds.

5  Reconnect the system (plug the transformer back 

into the power outlet).

6  Repeat steps (2) to (5) several times.

7  When steps (2) to (5) have been correctly followed 

three times in a row, the Garden Lights Plus lights 

will flash red several times.

8  Wait until the lights stop blinking and light up white. 

The factory settings have now been restored and 

the lights are ready for use again.