EDM1-IMX6 HARDWARE MANUAL
– VER 1.00 – NOV 14 2019
Page
30
of
80
2.7.2 MIPI Display
The MIPI DSI Host Controller supports the following features:
IPU SIDE (input):
•
Compliant with MIPI Alliance Specification for Display Serial Interface (DSI), Version 1.01.00 - 21
February 2008
•
Fully Compliant with MIPI Alliance Standard for Display Pixel Interface (DPI-2), Version 2.00 15
September 2005 with Pixel Data bus width up to 24bits
•
Compliant with MIPI Alliance Standard for Display Bus Interface (DBI-2) Version 2.00 - 29
November 2005.
Supported DBI types are:
•
Type B
•
16bit, 9bit and 8bit Data bus width
•
DBI and DPI interface can coexist (only one is operational at a time)
•
Support all commands defined in MIPI Alliance Specification for Display Command Set (DCS),
Version 1.02.00 - 23 July 2009
D-PHY side (output):
•
Interface with MIPI D-PHY following PHY Protocol Interface (PPI), as defined in MIPI Alliance
Specification for D-PHY, Version 1.00.00 - 14 May 2009
•
Supports up to 2 D-PHY Data Lanes:
•
Bidirectional Communication and Escape Mode Support through Data Lane 0.
•
Programmable display resolutions, from 160x120(QQVGA) to 1024x768(XVGA).
•
Multiple Peripheral Support capability, configurable Virtual Channels.
•
Video Mode Pixel Formats, 16bpp(RGB565), 18bpp(RGB666) packed, 18bpp(RGB666) loosely,
24bpp(RGB888).
For additional details, ple
ase refer to the “MIPI DSI Host Controller” chapter of the “i.MX6 Reference
Manual”.
Table 8 - MIPI Display and Camera Expansion Connector Signal Description
Pin #
i.MX6
PIN
PAD NAME
Signal
V
I/O
Description
1
F3
CSI_CLK0P
CSI_CLK0_P
2V5
I
MIPI Camera Serial Interface
clock pair positive signal
2
F4
CSI_CLK0M
CSI_CLK0_M
2V5
I
MIPI Camera Serial Interface
clock pair negative signal
3
GND
GND
P
Ground
4
E3
CSI_D0P
CSI_DATA0_P
2V5
I
MIPI Camera Serial Interface
data pair 0 positive signal
5
E4
CSI_D0M
CSI_DATA0_M
2V5
I
MIPI Camera Serial Interface
data pair 0 negative signal
6
GND
GND
P
Ground
7
D2
CSI_D1P
CSI_DATA1_P
2V5
I
MIPI Camera Serial Interface
data pair 1 positive signal
8
D1
CSI_D1M
CSI_DATA1_M
2V5
I
MIPI Camera Serial Interface
data pair 1 negative signal
9
GND
GND
P
Ground
10
E2
CSI_D2P
CSI_DATA2_P
2V5
I
MIPI Camera Serial Interface
data pair 2 positive signal
