TIMER SETTING PROCEDURE.
•
Press the 1 HR TIMER button. The 1-HOUR ON TIMER mark
will appear on the display .
1-HOUR TIMER cancellation procedure.
• Press the ON/OFF button to turn the air conditioner off.
• Wait for the indoor unit to stop operating.
• Press the ON/OFF button again to turn the air conditioner on.
•
If the 1-HOUR TIMER button is pressed after a certain time
is elapsed from the setting operation, the 1-HOUR timer
function is activated again.
COMBINING THE 1-HOUR TIMER AND THE DAILY PROGRAM
•
The 1-hour timer can be activated after the daily program
setting (par. C).
•
If the 1-HR TIME is pressed with the TIMER set in OFF
( sign on the display) this setting will be cancelled as
the 1-HOUR TIMER is activated, the air conditioner runs for
1 hour and then it stops.
NOTES
DISPLAY AFTER THE SETTING OPERATION
HORIZONTAL
The horizontal air flow can be adjusted by moving the vertical
vanes to the left or right, as indicated in the following figure.
ADJUSTING THE AIR FLOW DIRECTION
Set vertical vanes to the front position during COOLING/DRY
operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet and
drip off.
CAUTION
VERTICAL
Hold the end of the flap and move it up and down to adjust the
vertical air flow.
If you have lost the remote control unit or it has troubles, follow the
steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner, switch the operation
selector to the OFF position, and then to the ON position.
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
The set temperature and fan speed are automatically set at
the last selection before stopping.
NOTE
SETTING THE 1-HOUR TIMER
This function causes the unit to operate for one hour at the set
conditions, regardless of whether the unit is on or off.
Vertical Vane
TEST OFF ON
TEST OFF
ON
Horizontal Vane
2. WHEN THE AIR CONDITIONER IS RUNNIG
If you want to turn off the air conditioner, switch the OPERATION
SELECTOR to the OFF position.
Power failure during operation.
In the event of power failure, the unit will stop. When the power is
resumed, the unit will restart automatically after 3 minutes.
NOTE
SOLVENT
PETROL
CARE AND CLEANING
For safety, be sure to turn the air conditioner off and also to
disconnect the power before cleaning.
●
Some metal edges and the condenser fins
are sharp and may cause injury if handled
improperly; special care should be taken
when you clean these parts.
●
Periodically check the outdoor unit to see
if the air outlet or air intake are clogged
up with dirt or soot.
●
The condenser and other components of
the outdoor unit must be cleaned
periodically.
Consult your DEALER or AFTER SALES
SERVICE.
OUTDOOR UNIT
(CASING AND CONDENSING COIL)
CAUTION
TEST OFF ON
INDOOR UNIT
●
Do not pour water on the unit to
clean it. This will damage the internal
components and cause an electric
shock hazard.
●
Never use solvents, or chemical
agents when cleaning the indoor
unit. Do not wipe the plastic casing
using very hot water.
Casing and Grille
Clean the casing and grille of the
indoor unit with a vacuum cleaner
brush, or wipe them with a clean, soft
cloth. If these parts are stained, use a
clean cloth moistened with a mild liquid
detergent. When cleaning the grille, be
careful not to force the vanes out of
place.
8
OPERATION
SELECTOR
TEST OFF
ON
EG
