AC Power Cord Connection
To connect the power cord to your
hybrid
simply plug female side of the power cord into the power
cord input which is on the rear of the
unit
. Then plug the male side of the power cord to an electric
outlet. The AC power cords supplied purposefully have 2 blades and one grounding prong. If your
outlet is not equipped to handle this type of plug, do not attempt to forcefully plug this AC power cord
into the outlet, and do not alter the plug so that it can fit in the outlet. The only course of action you
can take is to find another outlet which is properly equipped to handler a grounded plug or have an
electrician upgrade your electrical outlet.Be sure that the plug is well connected so that it does not
disconnect in the middle of usage. If at any point in time the supplied AC power cord is punctured or
damaged replace it with a new power cord from a local electrician.
NOTE: ONLY PLUG IN THE AC POWER CORD WHILE THE UNIT’S POWER IS OFF AND THE
VOLUME IS TURNED DOWN. TURNING ON THE UNIT WITH THE VOLUME TURNED UP MAY
CAUSE THE UNIT OR ANY SPEAKERS CONNECTED TO IT TO BE DAMAGED. ALWAYS TURN
DOWN THE VOLUME PRIOR TO TURNING OFF THE UNIT.
The hyrids are designed to power up to two groups of full-range passive loudspeakers,three surround speakers
and two subwoofers.The speakers should be connected via the speaker wire outputs on the rear of the hybrid.
Connecting the Hybrid to Passive Loudspeakers
Input / Output Connections
Connecting the Signal Source to the Hybrid(DVD/MIXER/MP3 etc.)
NOTE: BE SURE NOT TO CONNECT AN AMPLIFIER OR ANY AMPLIFIER SIGNAL INTO THE RCA INPUT
JACKS. AS THIS COULD DAMAGE THE HYBRID. NO OTHER AMPLIFIER IS NEEDED TO POWER YOUR
SIGNAL IN ADDITION TO THE HYBRID. ALWAYS MAKE SURE THAT THERE IS ONLY ONE AMPLIFIER
IN THE SIGNAL PATH.
There are also input jacks for a MP3 player,USB flash drive and SD card on the front panel of the hybrid
which is compatible with iPod™(Classic and Nano) via the USB input. Just plug the MP3 player,USB flash
driver,SD card or iPod™(Classic and Nano) into their respective input jacks and set the hybrid to the
corresponding input. Be sure that the volume of your MP3 player and hybrid are turned down at first and
then slowly raise the volume to prevent damage the speakers or any of your other equipment.
The unit has two RCA input jacks on the rear of the unit which is designed to receive the signal directly
from your CD,mixer or any of your othersources.To ensure that you have correctly connected your CD
player (other sound sources) to the unit, make sure that the CD playe rhas a RCA cord coming from
its output and that this cord is plugging into the RCA Input on the rear of the HYBRID. There are also
RCA input jacks especially for 5.1 Channel signal from DVD player. Ensure that the polarity of your
signalis always maintained by using color coordinated RCA cables.
NOTE: WHEN MAKING THESE CONNECTIONS THE POWER OF THE HYBRID AND THE SIGNAL SOURCE
SHOULD ALL BE IN THE OFF POSITION WITH THE VOLUME LEVELS TURNED DOWN. ONCE THE UNITS
ARE ALL POWERED ON, SLOWLY INCREASE THE VOLUME TO AVOID DAMAGING ANY OF YOUR
EQUIPMENT. THE HYBRID OPERATE MOST EFFICIENTLY WHEN USED WITH 8 OHM SPEAKERS.
Power Cord, MP3 Cable, User Manual, Warranty, Remote Control, Antenna, Catalog.
Accessories
Hybrid Series
iPod™ & iPhone™ are registered trademarks of Apple Computers, Inc. Apple Computers, Inc. is not endorsing, sponsoring, or otherwise affiliated with this manufacturer.
