Hybrid Series Rear Panel
1.Power Supply:
Only use the power cord provided with the unit to power the unit. When connecting and
disconnecting the power cord, be sure the power of the unit is off. Connect the cord to the rear of the unit and then
connect it to the outlet.
2.Voltage selector
: Select between 230V AC 50Hz / 115V AC 65Hz. When using with a 115V outlet, the unit should
be set to 115V.
3.Surround Speakers:
Connect your surround speakers to these speaker outputs. The unit should be powered off
and volume levels turned down when making these connections. THE SURROUND SOUND SPEAKER ONLY
WORK WHEN ALL THE SURROUND SPEAKER OUTPUTS ARE CONNECTED TO SPEAKERS.. The surround
sound speakers all operate in conjunction with the Channel A speakers, therefore the Channel A speakers must be
selected on the front panel for the surround sound speakers to function.
4.Group A Main Speakers:
Connect your main speakers to these speaker outputs. The unit should be powered off
and volume levels turned down when making these connections. THE HYBRID OPERATE MOST EFFICIENTLY
WHEN USED WITH 8 OHM SPEAKERS.
5.Group B Main Speakers:
Connect your main speakers to these speaker outputs. The unit should be powered off
and volume levels turned down when making these connections. THE HYBRID OPERATE MOST EFFICIENTLY
WHEN USED WITH 8 OHM SPEAKERS.
6.SUB Outputs:
Connect the sub output to either a recording device, another amplifier or a powered (active)
subwoofer.The signal from the line output is a passive output and cannot be connected directly to a passive speaker.
7.Pre Output:
Connect the line output to either a recording device or another amplifier. The signal from the line
output is a passive output and can not be connected directly to a passive speaker.
8.REC LINE Output:
Connect the REC line output to a recording device. The signal from the line output is a passive
output and cannot be connected directly to a passive speaker.
9.DVD Input:
Connect any stereo signal output such as a DVD, CD, TAPE, Mixer etc to this input. To play a signal
connected to this input make sure the DVD input is selected on the front panel.
10.VCD/CD Input:
Connect any stereo signal output such as a DVD, CD, TAPE, Mixer etc to this input. To play a
signal connected to this input make sure the VCD/CD input is selected on the front panel.
11.FM & AM Antenna:
Connect your FM and AM antennas here.
Hybrid Series
6
7
8
9
10
11
