Hybrid Series
10.Balance Control:
Press these buttons to adjust the balance effect of master output.
11.Bass Control:
Press either of these buttons to increase or decrease the bass effects on the main
output.
12.EQ Mode Selector:
The hybrid has five built-in pre-set equalization modes. Press this button to
switch among the pre-set equalization modes.
13.P.Call:
Press this button to switch entry functions in tuner mode. Press this button the first time,
and then press the number keys to enter the frequency. Press this button again and then press the
number keys to enter the stored station’s number. For example, in FM mode,press this button the first
time and press 956,the unit will go to 95.6Mhz. Press the “P.Call” button again and then press 12, the
unit will go to the number 12 FM station stored.
14.LOUDNESS:
Press this button to adjust the loudness effect on the main output.
15.Number Keys:
The number keys are used to input the track number,station number or frequency.
For example if you press 6-4-3 , then ENTER, the unit will go to track number 643 on either the USB
flash drive,SD Card or iPod™(Classic and Nano). If you do not press ENTER after inputting the track
number there will be a delay of about 5 seconds before the unit goes to track number 643. This
funciton will only function for the USB flash drive,SD Card or iPod™ (Classic and Nano) signals. In
tuner mode, after pressing the PCALL button (13) press these buttons to enter the station frequency or
stored station number.
16.NEXT 10 & PREV 10:
Press either of these buttons to quickly go 10 tracks ahead or back. This
button will only function for the USB flash drive,SD Card or iPod™(Classic and Nano) signals.
17.Random Control:
Press this button to play random tracks on the USB flash drive,SD Card or
iPod™(Classic and Nano). Press again to turn this function off.
18.Repeat Control:
Press this button to repeat the current track, all tracks on the USB flash drive,SD
Card or iPod™(Classic and Nano). The unit’s default setup is repeating all tracks. Press this button
once to repeat the current track, press again to repeat all tracks.
In tuner mode to save a specific
frequency (station), go to the station and then press the “RPT/RDM” button on the face of unit or the
“RPT” key on the remote control and then using the number keys on the remote enter a number for the
saved station. The number entered should be between1 and 30. After entering the numbers, press the
“RPT/RDM” button or “RPT” key again to save. And the unit will exit the scan and play the station stored.
19.Mono & Stereo Control:
Press this button to switch the audio output between mono and stereo.
It only functions for tuner input.
20.AM & FM Control:
Press this button to switch between AM tuner and FM tuner. In tuner mode,
press this button and hold for a few seconds, the unit will scan all the available stations and save
automatically. The scan will be ended if this button is press again during the scan.
21.Recording:
When the input selected is TUNER/MP3/DVD/CD/VCD and there is an USB flash drive
or SD card (with blank space on it) inserted into their respective slot, pressing and holding this button
will activate the recording function.Press this button and hold for several seconds and the word “REC”
will display on the screen. The unit will create a new file in the connected USB flash drive or SD card
and get ready to make a recording. At this point there is no actual recording yet. Press the button
again and the unit will start recording onto the USB flash drive or SD Card and the elapsed time and
“REC” will display on the screen. Press the button a third time to pause the recording and the word
