GB-11
GB-10
INSTALLATION
Position the appliance and allow it to stand for
two to three hours before it is turned on for
the first time to allow the system to settle. Do
not position next to any heat source e.g. cooker,
boiler or in direct sunlight etc.
Allow at least 10cm of space at the top and 10
cm of space on both sides of the appliance and
between the back of the appliance and the wall
for adequate air circulation. The appliance is not
designed for recessed installation (“building in”).
Install on a good firm level surface, and any
unevenness of the floor should be corrected
prior to installation, slight unevenness can be
overcome by adjusting the front feet.
NOTE:
If the appliance is positioned on a carpet, soft
floor covering you should readjust the front feet
once the appliance has had time to settle.
In order to prevent the device from being tilted,
the door bracket must be placed on a flat surface,
such as a floor, table, etc.
USE
• This appliance is designed to operate in
ambient temperature between 16°C and
43
°C.
If these temperatures are exceeded, i.e. colder
or warmer, the appliance will not operate
correctly.
• Remove all packaging materials from the
appliance. Wash the inside of the cabinet
with lukewarm water and bicarbonate of soda
(5ml to 0.5 liter of water). Dry the appliance
thoroughly.
• When you use the fridge for the first time or
after defrosting, set the thermostat control
to the maximum position for at least 2 hours
before introducing food to be stored, and then
readjust to the normal position.
• If there is a power failure, do not open the
GB
GB
