GB-13
GB-12
door. Frozen food should not be affected
if the failure lasts for less than 12 hours. If
the failure is longer, then the food should
be checked and either eaten immediately or
cooked and then re-frozen.
SETTING THE THERMOSTAT KNOB
The refrigerator is controlled with a thermostat
knob located inside the fridge, towards the
upper right-hand corner. Turn the knob from
the STOP (OFF) position towards the higher
numbers for colder temperatures. The knob can
be adjusted from setting Min to Max.
Higher settings on the knob (max) mean lower
temperatures (colder) in all compartments of the
appliance.
Changes of the ambient temperature affect
temperature in the interior of the appliance
so choose a correct setting of the temperature
control knob, depending on your ambient
conditions.
In the STOP (OFF) position the appliance does
not operate (the cooling system is switched off),
but power supply is not interrupted.
Please Note:
If the appliance is switched off you
must wait at least 5 minutes before restarting the
appliance or re-inserting the plug into the wall
outlet. This is to allow the protection device in
the compressor to reset.
If the compressor fails to start correctly remove
the plug and wait for 5 minutes before you
try again then the compressor should restart
normally.
The storage temperature may be affected by:
– The room temperature
– How often the door is opened
– How much food is stored
– Position of the appliance
When you set the correct temperature, all these
factors mentioned above shall be taken into
account.
TEMPERATURE INDICATE
In order to help you get the correct adjustment
of your device, it is equipped with a temperature
gauge placed in the coldest area.
For the proper storage of food in your
refrigerator and in particular in the coldest area,
make sure that “OK” appears in the temperature
indicator.
GB
GB
