Technicolor TCV2480A, Instruction Manual

*

S AF E T Y P R E C AUTION

C AUTION

WARNING

:

P L AC E ME NT INF OR MAT ION

S AF E T Y INF OR MAT ION

CONDENSATION INFORMATION

RATING PLATE LOCATION

FCC STATEMENTS

CLASS 1 LASER

PRODUCT

WA R NING

:

CAUTION MARKING WAS LOCATED AT THE REAR
 OF THE APPARATUS.

WARNING:TO REDUCE THE RISK OF ELECTRIC
SHOCK

ˈ

DO NOT REMOVE COVER

˄

OR BACK

˅

NO USER SERVICEABLE PARTS INSIDE

.

REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.

The lightning flash with arrowhead symbol, 
within an equilateral triangle,is intended to 
alert the user to the presence of uninsulated

“

dangerous voltage”within the product's enclosure

 that  may beof sufficient magnitude to constitute a
 risk of electric shock to persons.

The exclamation point within an equilateral 
Triangle is intended to alert the user to
The presence of important operating and

maintenance (servicing) instructions in the literature
accompanying the appliance.

                         CAUTION
INVISIBLE  LASER RADIATION WHEN
OPEN AND INTERLOCKS DEFEATED
  AVOID EXPOSURE TO BEAM

    This product

 Contains a low
power laser device.

DANGER OF EXPLOSION IF BATTERY IS

INCORRECTLY REPLACED. REPLACE ONLY

WITH THE SAME OR EQUIVALENT TYPE.

TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
TO REVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE. DO
NOT PLACE OBJECTS FILLED WITH LIQUIDS ON
OR NEAR THIS UNIT.
SHOULD ANY TROUBLE OCCUR, DISCONNECT
THE AC POWER CORD AND REFER SERVICING
TO A QUALIFIED TECHNICIAN.

Do not use this unit in places that are extremely
hot, cold, dusty or humid.
Do not restrict the airflow of this unit by placing it

somewhere with poor airflow, by covering it with

a cloth, by placing it on bedding or carpeting.

When connecting or disconnecting the AC power
cord, grip the plug and not the cord itself. Pulling
the cord may damage it and create a hazard.
When you are not going to use the unit for a long
period of time, disconnect the AC power cord.

When left in a heated room where it is warm and

damp, water droplets or condensation may form
inside the equipment. When there is condensation
inside the unit, the unit may not function normally.
Let the unit stand for 1-2 hours before turning the
power on or gradually heat the room and let the
unit dry before use.

The rating plate is located on the rear of the unit.

NOTE: This unit has been tested and found to comply

with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation.
This unit generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful

interference to radio communication. However, there
is no guarantee that interference will not occur in a
particular installation. If this unit does cause harmful
interference to radio or television reception, which

can be determined by turning the unit off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the unit and
receiver.
-Connect the unit into an outlet on a circuit different

from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV
technician for help.

Changes or modifications to this
unit not expressly approved by the party responsible
for compliance could void the user authority
to operate the unit.

1

USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.

“

HDMI, the HDMI logo and High-Definition Multimedia

Interface are trademarks or registered trademarks of
HDMI Licensing LLC.”