20
(20)
Settings
Sound adjustment, Other settings
1 Press [SETUP].
2 Press [ ], [ ] repeatedly to select the menu and then press [OK].
3 Press [ ], [ ], [ ], [ ] to select a desired item or value, and press [OK].
The sound effects and other settings can be set up.
Adjusting BASS/MID/TREBLE
“Tone Control”
The tone can be adjusted by pressing [BASS]/
[MID]/[TREBLE].
•
The tone adjustment is enabled by pressing
[BASS]/[MID]/[TREBLE] and “Tone Control” is
set to “On”.
•
Each level can be adjusted between “-10” and
“+10”.
•
While connecting Technics device supporting
system control function (Network Audio
Player, etc.) to this unit, sound setting on the
connected device may have a priority over this
unit. Adjust the sound with the connected
device.
•
Not available when using this unit as power
amplifier (
18). Adjust the sound with the AV
receiver, control amplifier, etc.
•
Set “Tone Control” to “Off” to cancel the
adjustment of “BASS”, “MID” and “TREBLE”.
Adjusting balance of speakers
“Balance L/R”
Adjusts the balance of the output from left and
right speakers.
•
Each level can be adjusted between 18 dB (L)
and 18 dB (R).
•
The audio output from the connected
headphones and PRE OUT terminals are also
adjusted.
•
While using this unit as power amplifier (
18),
this setting is disabled. Adjust the setting with
the connected device.
Adjusting the volume attenuator
“VOLUME Attenuator”
Set to “On (-20dB)” for the attenuator to ease
the volume adjustment at a low volume.
•
The factory default is “Off”.
•
”ATT” is displayed after setting.
•
Not available when using this unit as power
amplifier (
18). Adjust the sound with the AV
receiver, control amplifier, etc.
MQA decoding
“MQA Decoding”
This unit includes the MQA (Master Quality
Authenticated) technology, which enables
playback of MQA audio files and streams,
delivering the sound like the original master
recording.
The built-in MQA decoder will restore the
highresolution signal heard in the studio and
confirm it, using the authentication signature.
Visit
www.mqa.co.uk/customer/mqacd for more
information.
To deliver the sound like the original master
recording, MQA decoding function needs to be
set to “On”.
•
“MQA”, “MQA Studio”, etc. are displayed while
playing back the MQA audio files and streams.
Selecting the speaker terminals to
output
“SPEAKERS”
Select the speaker terminals from which audio
will be output.
•
The factory default is “A”.
