12
Note: You can re-tune your box
again at any time. See Channel
tune on page 20~21.
Operating the box
3. Press
OK
to begin the automatic tune.
4. The box searches for and displays all
the available TV and radio channels.
5. Once the automatic search has been
completed, you will be prompted to
select ‘Yes’ to see the list of channels or
‘No’ to start watching TV.
Basic operating instructions
Switching on for the first time
You need to perform automatic channel
tuning when you turn the box on for the first
time
To perform automatic tuning:
1. Make sure your box is connected to the
mains and that it is connected to the aerial
2. Press to turn the box on. After a short
time, a welcome menu will be displayed.
Standby
Press to put the box into standby,
Channel Zero’s services and content are
loaded in standby. See Channel Zero on page
27.
The box automatically goes into standby after
3 hours if you do not use the remote control.
You can adjust this time by changing the TV
settings. See TV on page 23.
Note: You can put the box into
low-power standby by pressing
for 3 seconds.
However, this will cause Channel
Zero’s content to be lost and the
box will have to be re-loaded
according to the basic operating
instructions – see Accessing
Channel Zero services on page
27.
Source selection
Press the
TV / R
button to switch between TV
and radio channels.
Summary of Contents for Freeview STBHDIS2010
Page 1: ...Freeview HD Set Top Box Model STBHDIS2010 ...
Page 2: ......
