SAFETY : Read this First !
•
Do not connect the appliance if there are obvious signs of transportation
damage.
•
Read this user manual thoroughly before attempting to use this appliance.
•
Installation and repair should be attempted only by qualified technical personnel.
•
It is dangerous to modify any part of this appliance.
•
The manufacturer declines all responsibility in case of failure to adopt proper
safety measures.
•
Ensure the location in which this appliance is installed has good, permanent
ventilation.
•
The distance between the bench top to the lower part of the hood must not be at
less than 65 cm or higher than 75 cm.
•
Use an electrical connector with earth that is correct for your location.
•
Check that the voltage in your area is correct before plugging in.
•
The electrical connection of this appliance must be connected to earth.
Green & yellow
= EARTH
Blue =
NEUTRAL
Brown
=
LIVE
•
Multiple plugs and extension cables must not be used. Overload is dangerous
and may cause a fire.
•
Ensure that the power supply chord is free from any heat source or sharp
objects.
•
The appliance should be switched off and the electrical supply disconnected
before any cleaning or maintenance work can be carried out..
•
This
appliance
is
not
intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
4
Cleaning & Maintenance
(continued)
Activated charcoal filter
To install the charcoal filter, the motor anchorage is made to coincide with the
anchor points of the activated charcoal filter, inserting and locking into place.
The carbon filter lasts from three to six months depending on the particular
conditions of use.
The activated carbon filter can neither be exhausted, it must be changed.
Once it is exhausted, it must be changed.
Changing Bulbs
Remove the filter support to access the bulbs.
Take care to disconnect the mains beforehand and that the bulbs to be
replaces are not hot.
The maximum bulbs power is 40W.
13
