SAS UG 202205-01
41
SAFETY ARM SYSTEM INSTALLATION (CONTINUED)
INSTALLING THE STANDARD SURFACE BASE ONTO THE SAFETY ARM SYSTEM UPPER PLATE (CONTI-
NUED)
CAUTION
9
Before operating the arm, clear any obstacles that may interfere and cause injury to the operator, patient or that
may damage the medical equipment.
9
Always keep a safe distance from the foot end of the cot/stretcher, clear of any obstacles while operating the arm.
Maintain a minimum distance of at least 24 inches (2 feet) while operating.
WARNING
9
Improper usage of the Safety Arm System can cause injury to the patient or operator. Operate the product only as
described in this user guide.
9
Do not allow untrained staff to assist in the operation of the arm. Untrained technicians/staff can cause injury to
the patient or themselves.
9
Always hold the arm securely when you manipulate it not to drop the safety arm. Dropping the arm could cause
injury to the operator or patient.
9
Always pull and hold the locking safety pin (red handle) until it reaches the final position (up (locked) or down
(unlocked)) so the arm doesn’t fall during transport. Failing to do so can cause injury to the operator or patient.
Operation Caution and Warning
MIN 2 FT
Always
reposition
the arm to
ensure the cot
is balanced
FIGURE 18. PATIENT COT/STRETCHER
WITH SAFETY ARM SYSTEM INSTALLED
