35
DE
EN
• Check the voltage stated on the type plate and use the charging station only with a suitable
power supply voltage.
• Do not continue using the device if you are unsure whether it is functioning correctly, or
may be damaged - switch it off and set the main power circuit breaker and residual current
device to OFF. Contact your local dealer.
• The ambient temperature must be between –35 °C and +55 °C, without direct sunlight, and
relative humidity must be between 5 % and 95 %. The charging station must be only used
within these operating conditions.
• The device must be located in a position that avoids excessive heating up of the charging
station. High operating temperatures, caused by direct sunlight or sources of heat, can
reduce the charging current or can temporarily interrupt the charging process.
• The charging station is designed for both outdoor and indoor use.
• In order to reduce the danger of fire and the danger of electrocution or product damage,
do not expose the device to rain, snow, thunderstorms or other severe weather events. In
addition, the charging station must not be exposed to spillages or sprayed fluids.
• Do not touch the connection terminals, the electric vehicle plug and all other live parts on
the charging station with sharp metal objects.
• Avoid contact with sources of heat and locate the device at a safe distance from flammable,
potentially explosive, reactive, and combustible materials, chemicals and vapours.
• Explosion risk This device has parts within it that may cause electric sparks and discharges
and which should never come into contact with flammable vapours. It must not be installed
in recesses or cellar rooms.
• The device is intended only for the charging of electric vehicles whose charging can be
carried out without ventilation.
• In order to prevent the danger of an explosion or electrocution, make sure that the stipulated
line protection switch and the ground fault circuit interrupter are correctly connected to
the electric mains in the building.
• The bottom of the charging plug socket (TECHNIVOLT 100) should be located at a height of
1 m to 1.5 m above floor level.
• One must not use adapters or conversion adapters. Cable extension leads must not be used.
• The charging station must not be installed in areas where there is a danger of high water.
5.1 Safety instructions for the earthing system
• The charging station must be connected to a centrally earthed system. The earth line that
goes into the charging station must be connected to the grounding lug of the device. This
must be carried out with power circuit conductors while connected to the earthing rail of the
device or on the charging station. Connection to the charging station is the responsibility
of the installer and the purchaser. In order to reduce the danger of electrocution, connect
the device using only properly earthed plug sockets.
• WARNING! Make sure that the charging station is constantly and properly earthed during
installation and use.
