15
LOF high band
In this line, use the
numeric keys
to enter the LOF of the
high band of your LNB.
Switchover LOF low//high
In this line, use the
numeric keys
to enter the frequency at
which your LNB switches from the low band to the high band.
Press
OK
to accept the setting and store it in memory.
Signal/Quality
If you have entered the parameters of the test transponder
correctly, this line will indicate the signal strength and quality.
5.4.4 Rotating antenna
If you are operating the receiver in conjunction with a rotating
antenna driven by a DiSEqC motor ( Level 1.2), switch the
DiSEqC Control
(Point 5.4.1)
on
and please note
Point
8
of the operating manmual.
6 Operation
6.1 Switching on and off
>
Switch the receiver on by pressing the
On/Standby
key on the front panel of the unit, or on the remote
control.
>
Pressing the same key again - on the unit or on the
remote control - will switch the receiver off again.
>
The unit is now in standby mode, ready for use.
Please note:
When switching the receiver off, all current settings are
automatically stored in memory. For this reason the
unit can only be switched on again after a period of
approx. 15 seconds.
6.2 Programme selection
6.2.1 Using the Programme keys up/down
>
You can switch from one programme to another, one
slot at a time, using the
programme keys up/down
either on the receiver itself or on the remote control
unit.
6.2.2 Using the numeric keys
>
You can use the
numeric keys
to enter the desired
programme number directly.
For example:
1
for programme slot 1
1,
then
4
for programme slot 14
2,
then
3,
then
4
for programme slot 234
bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 15
