7.5.2 Delete all programmes
This function allows you to delete totally the programme
memory banks.
>
Use the
arrow keys up/down
to mark the line
Delete
all programmes
.
>
Press
OK
. The message “Do you really want to delete
all programmes?” will be displayed
Use the
arrow keys left/right
to indicate
Yes
or
Abort
.
>
Confirm by pressing
OK
.
Please note any messages displayed on your screen.
7.5.3 Updating software
In addition, you have the facility to update the operating
software of your receiver via satellite (ASTRA 19° East).
>
Use the
arrow keys up/down
to mark the item
Update software
.
>
Press
OK.
The sub-menu
Update software
will be
displayed.
(Fig. 7-15)
To update your software, mark the item
Update
software.
>
Use the
OK
key to switch the software update function
On
.
>
Press the
Menu
key to return to normal operation.
In order for the new software to be downloaded
overnight, the receiver must remain in stand-by
mode.The download procedure is indicated by a
blinking LED light on the unit.This procedure
must not be interrupted by switching the unit on
or off, nor may it be disconnected from the mains
power supply.
>
To start the update of the operating software manually,
press the
red
function key (Test) in the menu
Software Update
.
To download any new software that may be available,
follow the instructions displayed on your screen.
Should the parameters of the data channel used to download
software updates have changed, you can correct them in this
menu as described under Point 7.4.3 (manual programme
search). Current transponder data can be obtained from your
specialist retailer. In general, however, you should not make
any changes in this menu.
Note:
This function should not be activated if you have
made changes in the menues Basic Settings
and LNB configuration, as any changes made
there would be deleted when this function is
performed, and you would have to repeat the
changes there
32
(Fig. 7-15)
bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 32
