33
7.6 System configuration
You can use this menu item to view the specific unit data.
>
Use the arrow keys up/down to mark this line in the
sub-menu Settings.
>
Confirm by pressing
OK
.
>
Press the
Menu
key to return to normal operation.
7.7 Encryption system
Use this menu item to go to the sub-menues related to the
CA module. Use the arrow keys to mark the CA module, then
confirm by pressing
OK
to obtain information on the card
currently inserted.
8 Operation in conjunction with a rotary
antenna
Your receiver is equipped to operate in conjunction with a
rotary antenna. The DiSEqC control feature (DiSEqC-Level
1.2) allows you to control an appropriate motor to rotate the
antenna, via the coaxial connection.
>
As described in Point 5.4, call up the menu
LNB
Settings
(Fig. 8-1) and switch the
DiSEqC control
(Point 5.4.1) to
on
.
>
Use the arrow keys up/down to select the DiSEqC
position (e.g. A/B 3) to which you wish to allocate the
motor-driven rotating antenna.
>
Press
OK
to open a window allowing you to select the
Satellites
resp. the
Motor antenna
.
(Fig. 8-2)
>
Use the
arrow keys up/down
to select the item
Motor antenna
.
>
Confirm by pressing
OK
.
>
Observe the message displayed
(Fig. 8-3) regarding
the setting of East and West limits, confirm by
pressing
OK
.
8.1 Eastern and Western limits
To avoid mechanical damage to the antenna dish or to the
LNB, caused by obstacles that may be in the way, you should
determine the maximum rotating range in both easterly and
westerly direction.Where there are structural obstacles, such
as chimneys or walls, these must definitely be considered
when setting the East-West limits. If there are no obstacles in
the rotating range, then you should determine the limits in
such a way that they are just a little beyond the most extreme
positions of the satellites from which you wish to receive
signals.
8.1.1 Deleting existing limits
You should first delete any existing limits set.
(Fig. 8-1)
(Fig. 8-2)
(Fig. 8-3)
bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 33
