>
Press
OK
.
>
Use the
arrow keys up/down
to select the desired
position.
>
Confirm by pressing
OK
.
The dish will now be rotated to the selected position.
The rotating procedure is indicated by a blinking
display “
Rotating
” in the menu.
8.4.1 Selecting a satellite position
To rotate the antenna to the position indicated in the satellite
list, your receiver is equipped with the function
Rotate to
sat.
.
>
Press the
yellow
function key (Actions) to open the
window listing the available actions.
>
Use the
arrow keys up/down
to mark the item
Rotate to sat
.
>
Confirm by pressing
OK
.
>
Press the
green
function key (Rotate to sat.) to rotate
the antenna to the selected position.
8.5 Deleting a satellite position
To delete a satellite position from the satellite list, proceed as
follows:
>
Use the
arrow keys
to mark the item
Current
satellite list
.
>
Press
OK
to display the current satellite list.
>
Use the
arrow keys up/down
to select the satellite
you wish to delete.
>
Confirm by pressing
OK
.
>
Use the
arrow keys
to mark the item
Delete sat..
>
To delete the selected satellite, press
OK
, a
confirmatory message will be displayed, then press
OK
again.
8.6 Reference position
When installing the external installation, the motor must be
parked in the reference position (
0°
). For this purpose you
can use the function “
Go to reference position
” at any time
to rotate to this position (
0°
).
>
Press the
red
function key (Ref.pos) to rotate the
antenna automatically to the reference position.
39
bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 39
