GB 8
HOW TO SYNCHRONIZE YOUR WEATHER STATION WITH ANOTHER
OUTDOOR TRANSMITTER
1.
At the back of your weather station, Press
c
/ CHANNEL
once.
icon appears under your outdoor temperature and
humidity.
2. Press and hold
c
/ CHANNEL
until the
icon blinks, your weather station is searching for the signal of another
outdoor transmitter at Channel 2.
3. Slide open the battery door of your second transmitter, slide the switch to the middle
position marked
with
2
, then insert two AAA batteries into the battery compartment by observing the c/- polarity.
Replace the battery cover.
4. The outdoor temperature and humidity of your second transmitter will appear on the LCD together with
icon within few seconds. If the data still does not appear, take out and reinstall batteries to your second
transmitter once.
5. To synchronize your weather station with a third outdoor sensor, repeat the same step by choosing
on
your weather station and select
3
on the switch on your third transmitter.
AUTO SCROLLING THE OUTDOOR TEMPERATURE AND HUMIDITY OF
DIFFERENT TRANSMITTER
Press
c
/ CHANNEL
one at a time until the
icon flashes with a short beep tone. Then the outdoor temperature and
humidity of different outdoor transmitter will be displayed for few seconds alternately with
,
,
flashing.
To stop the auto scrolling, press
c
/ CHANNEL
once to go back to constant display of the temperature
and humidity of the
transmitter, the
icon remains static on the display.
LOW BATTERY INDICATION OF YOUR OUTDOOR TRANSMITTER
The icon will appear to indicate the battery level of your outdoor transmitter is getting low. You may need to replace the
batteries of your outdoor transmitter with new ones.
Extreme cold weather (e.g. below 14
°
F) will also cause low battery voltage.
TROUBLESHOOTING
In case your weather station clock shows irrelevant information or digits, it maybe affected by electrostatic discharge or
interferences from other devices. Use a sharp object to press
RESET
at the back of your weather station. Your unit will be
reset to default settings and you need to set the time, calendar and alarm time again.