EN7
In area where reception of the radio-controlled time (DCF time) is not
possible, the time reception function can be turned OFF. The clock will
then work as a normal Quartz clock. (Default setting is ON).
1.
The digit “ON” digit will start flashing on the LCD.
2.
Use the
+
key to turn OFF the time reception function if necessary.
3.
Confirm with the
SET
key and enter the
Manual time setting
.
Note:
If the radio-controlled time reception function is turned OFF manually,
the clock will not attempt any reception of the radio-controlled time
(DCF time) as long as the time reception OFF function is activated. The
time reception icon and the DCF icon will not be displayed on the LCD.
Manual time setting
In case the weather station is not able to detect the radio-controlled
time (DCF time) signal (disturbances, transmitting distance, etc.), the
time can be manually set. The clock will then work as a normal Quartz
clock.
To set the clock:
1.
The hour digits start flashing in the time display section.
2.
Use the
+
key to adjust the hours and then press
SET
key to go to
the minute setting.
3.
The minute will be flashing. Press the
+
key to just the minutes.
4.
Confirm with the
SET
key and exit the setting mode.
Note :
The unit will still try to receive the signal despite a manual setting. When
the signal is received, the manually set time will automatically be
replaced by the received time. During reception attempts, the DCF
tower icon will flash. If reception has been unsuccessful, the DCF tower
icon will not appear but reception will still be attempted.
Alarm setting
To set alarm:
1.
Press and hold
ALARM
for about 3 seconds until the alarm time
display flashes.
2.
The hour digit and the alarm icon will be flashing. Press the
+
key
to adjust the hour.
