BIKE XT: Service & Maintenance manual - rev. 2.0
Page 7.5
7.5.
DISASSEMBLING THE CARDIO RECEIVER
Version A: receiver situated below the display.
Figure 7.5-1
1.
Turn off the machine and unplug the mains
lead from the wall output.
2.
Remove the label from the CARDIO
RECEIVER box using the blade of a
screwdriver.
3.
Remove the 2 fixing screws
b
using a 3-mm
hex T-wrench.
4.
Open the box.
5.
Disconnect connector
a
.
6.
Remove the RECEIVER.
To reassemble the RECEIVER, carry out the
above steps in reverse order.
Before securing the screws, make sure
the cable is correctly positioned in order
to avoid squeezing it.
Version B: receiver situated inside display, secured by a strap.
Figure 7.5-2
Carry out the procedure described in paragraph
7.1. “Disassembling the display”.
With the display on a work bench:
1.
Cut the fixing strap
c
.
2.
Disconnect connector
d
of cable BK-7 from
the RECEIVER.
To assemble the new RECEIVER, with the
display on a work bench:
1.
Connect connector
d
of cable BK-7 to the
RECEIVER.
2.
Position the RECEIVER between the foam
pads
e
as shown in the figure at left.
3.
Passing the strap through clamp
f
, fix and
secure with the strap.
Summary of Contents for BIKE XT
