BIKE XT: Service & Maintenance manual - rev. 2.0
Page 7.14
7.11.
DISASSEMBLING THE PEDAL CRANK GROUP
Figure 7.11-1
Carry out the procedure described in paragraph
7.7. “Disassembling the right and left side
casings”.
1.
Unscrew the left pedal
c
using a 15-mm
wrench.
2.
Unscrew the fixing screws
a
of plate
b
using
an 8-mm wrench.
3.
Remove the plate.
4.
Open or unsprocket the chain.
Move the pulley cams to facilitate the
operation.
Figure 7.11-2
5.
Using a hammer and screwdriver, open the
locking tabs to release the left ring nuts of the
pedal crank group from the snap ring clamps.
Figure 7.11-3
6.
Unscrew the ring nuts as shown in the figure
at left, using 36-mm wrenches.
7.
Use an extractor to remove the left-hand
bearing.
8.
Remove the pedal crank from the right side.
Because the threads of the left pedal and
ring nuts are inverted, these components
must be unscrewed in a clockwise
direction.
To reassemble the PEDALS, carry out the above
steps in reverse order.
Summary of Contents for BIKE XT
