RUN EXCITE-2008: Service & Maintenance Manual - rev. 1.3
Page 9.7
9.1.16.
R
ESETTING PARAMETERS TO DEFAULT VALUES
It is possible to reset the user menu parameters to their default values. To select the function, when
the display shows:
DEFAULT CONFIG.
Press
ENTER
to confirm the operation, use the
+
or – effort level keys to move to the next or
preceding parameter. If the
ENTER
key is pressed the display will show:
CONFIRM ?
press
ENTER
to confirm, or cancel by pressing the
CLEAR
key for a few seconds.
9.1.17.
F
ORMAT
P&P
KEY
This function formats a TGS key for Plug&Play mode operation. To select the function, when the
display shows:
FORMAT P&P
Press
ENTER
to confirm. At the end of the formatting procedure, hold down the
CLEAR
key for a
few seconds to exit. The
CLEAR
key can be pressed at any time to interrupt the procedure and
revert to standby mode.
9.1.18.
U
SER
D
ETECT
This function is able to detect the presence of a user running on the tread belt during an exercise
session. It is possible to configure a minimum speed at which the machine will determine that the
user has stopped running on the treadmill, and interrupt the exercise session if the condition persists
for one minute. To change the setting, when the LED matrix shows the current duration:
USER DETECT: xxx
Press the
ENTER
key to change the parameter: when the current parameter value starts to blink,
press the
CLEAR
key to erase the current value and then use the number keys to enter the desired
new value.
Press
ENTER
to confirm the selection; use the
+
or
–
speed keys to move to the next or preceding
parameter.
The default value of this parameter is 5.0 km/h
The minimum threshold speed for the user detect function is 3.0 km/h. Entering any
value lower than this will have the effect of disabling the user-detect function.
If the unit of measurement is setted to IMPERIAL units (miles / pound), the default
value for this parameter is 3 mph while the minimum speed is 2 mph.
At the end of the format procedure, hold down the
CLEAR
key for a few seconds to exit. The
CLEAR
key can be pressed at any time to interrupt the procedure and revert to standby mode.
Summary of Contents for EXCITE Run 500
