JOG EXCITE: Service & Maintenance Manual - rev. 1.1
Page 10.5
10.4.4.
C
HECKING THE WEAR AND LUBRICATION OF THE TREAD BELT AND
RUNNING DECK
1.
Disassemble the rear and driving rollers, the running deck and the tread belt.
2.
Check the state of wear of both the running deck and the tread belt. Replace if there are evident
signs of wear.
3.
Using a clean cloth, wipe the entire surface of the running deck and the underside of the tread
belt.
WARNING: NOT lubricate.
4.
After reassembling the machine, start walking on it at a speed of approximately 3 km/h, being
careful to tread on the full width of the belt so as to distribute the oil over its entire surface.
10.4.5.
C
HECKING THE WEAR OF THE DRIVING ROLLER
1.
With the rear and driving rollers, running deck and tread belt disassembled, check the state of
wear of the driving roller. Replace if there are evident signs of wear.
2.
With the machine in motion, check the noisiness of the bearings. Replace in the event of
excessive noise.
10.4.6.
C
HECKING THE WEAR OF THE REAR ROLLER
1.
With the front and rear rollers, running deck and tread belt disassembled, check the state of
wear of the rear roller. Replace if there are evident signs of wear.
2.
With the machine in motion, check the noisiness of the bearings. Replace in the event of
excessive noise.
10.4.7.
C
HECKING THE SHOCK ABSORBERS
1.
With the front and rear rollers, running deck and tread belt disassembled, check the condition of
the shock absorbers on either side of the running deck. Replace if they are cracked or show
signs of breakage.
10.4.8.
C
HECKING THE TREAD BELT MOTOR DRIVE
-
BELT
1.
Turn off the machine by placing the switch in position 0 (OFF).
2.
Unplug the mains lead from the wall outlet.
3.
Open the motor guard.
4.
Check the state of wear of the tread belt motor drive-belt, turning it by hand using the motor
flywheel. Replace if there are evident signs of wear.
10.4.9.
C
HECKING AND CENTERING THE TREAD BELT
1.
With the machine stopped, check the tension over the entire surface of the tread belt, turning it
by hand. If any anomalies are found, call in an authorized Technogym service technician.
2.
With the machine moving at a speed of approximately 10 km/h, check the cantering of the tread
belt. If any anomalies are found, call in an authorized Technogym service technician or make
the adjustment.
Summary of Contents for JOG EXCITE
