JOG NOW : Service & maintenance manual - rev. 6.2
Page 7.23
7.8.
DISASSEMBLING THE INMOTION – (READY TO RUN)
BOARD
Figure 7.8-1
Turn off the machine and unplug the mains lead
from the wall outlet.
1.
Back off the screw
(a)
using a small Phillips
screwdriver.
2.
Remove InMotion board closing covering
(b)
from the handlebar.
Figure 7.8-2
3.
Unplug the connector
(c)
from the Board.
4.
Remove the Board
(d)
.
To reassemble the InMotion board, carry out the
above steps in reverse order.
Figure 7.8-3
Take care to reassemble it in the correct
way:
The light convector (e): it’s not possible
to mount it in the opposite way in order
to correctly fix it on the board.
The InMotion board: the upper corner
of the board (circled in the figure) has
been cut to correctly housing in the
plastic cover
Summary of Contents for Jog Now Excite+ 700
