RUN 600 XTPRO: Service & Maintenance Manual - rev. 1.3
Page 6.31
Is the elevation motor current
correct?
8
Lubricate the elevation
bars
NO
YES
B
Are the elevation bars lubricated?
Replace the elevation
motor
NO
YES
Replace the photocell
NO
YES
Does the elevation board output
the status signal?
NO
Replace the elevation board
YES
Is the pulse signal at the
photocell output correct?
9
10
Does the status signal reach
the CPU board?
Replace the CPU board
7
NO
Check and/or replace cable
between CPU board and
elevation board
YES
Follow the procedure step by step to correctly diagnose the problem. Take particular care with the
checks highlighted by circled numbers, which are described in detail below:
If the motor momentarily starts and stops immediately afterward continuously, there is
probably a problem with the photocell or its cable.
Summary of Contents for RUN 600 XTPRO
