6
Run Personal
2
Assemble and operate the equipment on a solid, level surface.
Keep all electrical components, such as the power cable and I/0 switch, away from liquids to prevent shock.
Maintain the equipment in good working condition. If there are signs of wear, contact the Technogym Technical Support service.
Do not attempt to service the equipment yourself other than the maintenance instructions found in the manual.
Do not set anything on the casing or control panel.
The equipment
must not
be placed close to heat sources or close to sources of electromagnetic waves (e.g. televisions, electrical motors,
aerials, cellphones, etc.).
Although the equipment has been designed and built in accordance with health and safety requirements, there are some zones in which
there are unseen hazards. You must be very careful about possible upper and lower limb crushing hazards.
!
Warning
Technogym s.p.a. will be held responsible for its equipment only if the following precautions are observed:
- the equipment must be used as specified;
- the User manual must be read thoroughly throughout;
- the place of installation must meet the requirements stated in the User manual;
- the electrical system must conform to the standards and legal requirements in the country of use;
- the installation, maintenance and setting must be done by qualified Technogym staff or persons authorised by Technogym;
- suitable clothing must be worn;
- towels and other items must not be put on the equipment.
