RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 7.19
The upper table of the RUNNING
TRACK can be inverted by turning it
over.
To reassemble the TREAD BELT and the
RUNNING TRACK, carry out the above steps in
reverse order.
When reassembling the TREAD BELT,
ensure that:
•
the TREAD BELT is oriented as
indicated by the arrow on the inner
side;
•
the TREAD BELT is correctly
centered on the RUNNING TRACK;
•
the TREAD BELT is not pinched in
the RUNNING TRACK.
Lubricate the RUNNING TRACK
before reassembling.
The RUNNING TRACK must be
reassembled with the 45° beveled part
toward the rear roller.
After completing this procedure, adjust
the tension and centering of the tread
belt as described in paragraphs 8.2. and
8.3. and adjust the tension and
alignment of the tread belt motor drive-
belt as described in paragraph 8.4. .
Summary of Contents for Runrace
