RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 7.22
Figure 7.17-4
9. Back off the 4 nuts
i
(2 are concealed by the
motor itself in the figure at left) fixing the
tread-belt motor to the machine frame, using
a 17-mm wrench and holding the screw
underneath in place with a 17-mm wrench.
10.
Pull out the TREAD-BELT MOTOR,
pushing it first inward and then upward to
remove the motor drive-belt.
To reassemble the TREAD-BELT MOTOR,
carry out the above steps in reverse order.
When locking down the cover screws,
ensure that the cables are correctly
routed inside the box to avoid pinching
them with the cover.
When reassembling the TREAD BELT
MOTOR, remeber to put the insulating
washer and spacer.
After completing the procedure, adjust
the tension and alignment of the motor
drive-belt as described in paragraph 8.4.
Summary of Contents for Runrace
