28
SKILLMILL
ROUTINE MAINTENANCE
The equipment should always be kept clean and free of dust, in compliance with good hygiene practice, as it is used in a gym by more than one person.
To clean the
display
, proceed as follows:
- Unplug the power cable from the wall socket, if present.
- Adjust the brake to slow down the rotating belt as much as possible.
- Clean the control panel with a damp, but not wet, cloth.
Every week,
clean the equipment completely
:
- Unplug the power cable from the wall socket, if present.
- Adjust the brake to slow down the rotating belt as much as possible.
- Clean the outside of the equipment using a damp sponge.
- Move the equipment to one side so that you can vacuum underneath it.
Do not use chemicals or solvents.
Warnings
Be careful not to rub too hard on the drawings and instructions shown on the labels.
The safety of the equipment is assured only on the condition that it is carefully inspected every two weeks for any signs of damage and/or
wear.
All cleaning and maintenance operations must be performed with the rotating belt completely stopped.
Call the Technogym Technical Support Service for instructions on any maintenance operations not described in this manual.
Summary of Contents for SKILLMILL DJK03
Page 1: ...SKILLMILL TM USER MANUAL...
Page 34: ...SKILLMILL__en AB 0SM00971...
