TOP 600 XTPRO: Service & Maintenance Manual - rev. 2.0
12.1.2. D
ISASSEMBLING THE STEM GUARD
Figure 12.1.2-1
Carry out the procedure described in paragraph
12.1.1. “Disassembling seat”.
1. Remove the yellow cover
a
.
2. Use a 4-mm Allen wrench to back off the
screw underneath.
3. Remove the knob
b
, pulling from the
opposite side of the stem guard.
Figure 12.1.2-2
4. Remove the rubber o-ring
c
.
5. Back off the threaded bushing
d
,
using a 17-
mm wrench.
6. Pull the spring and the pin out from outside
the frame.
Figure 12.1.2-3
7. Back off the screw which clamps knob
e
,
using a 4-mm Allen wrench.
8. Remove the knob
e
.
9. Pull the pin and the spring out from the
inferior the frame.
10. On both sides of the machine, back off the 2
screws
f
, using a medium Phillips
screwdriver.
11. Remove the stem guard, removing it from the
upper side.
To reassemble the stem guard, carry out the
above steps in reverse order.
Page 12.3
Summary of Contents for Top 600 XTPRO
