VARIO : Service & maintenance manual- rev. 4.2
Page 7.53
Figure 7.15-5
Disassembling the Cogged belt (B):
5.
Pull out the belt
(B)
from the right side
(pinion end) as shown in the figure.
6.
Remove the flywheel
(A)
.
Figure 7.15-6
Disassembling the Magnetic brake (C):
7.
Mark the position around the shaft on either
end using a marker pen, for use as reference
during reassembly.
8.
Back off the screw
(e)
using a 4mm
hexagonal wrench, and the nut
(f)
using a
17mm wrench and remove the internal and
external washer.
Figure 7.15-7
9.
Back off the nut
(g)
using a 17mm wrench
and remove the two washers.
10.
Back off the screw
(h)
using a 4mm
hexagonal wrench.
11.
Back off the 2 screws
(i)
using a 4mm
hexagonal wrench.
12.
Push the tensioned mechanism outward in
the direction of the arrow, and remove it
from the centre screw.
Continued on following page...
Summary of Contents for Vario Excite + 500
