32
To wall mount:
1.
Fix a screw (not supplied) into the desired wall, leaving the head extended out by
about 5mm.
2.
Place the weather station onto the screw, using the hanging hole on the backside.
Gently pull the weather station down to lock the screw into place.
Foldout table stand:
The foldout table stand leg is located on the backside. Pull the stand out from the
bottom center edge of the weather station, below the battery compartment. Once
the foldout table stand is extended, place the weather station in an appropriate
location.
POSITIONING THE THERMO-HYGRO TRANSMITTER:
Mounting at a sheltered place. Avoid direct rain and sunshine.
The thermo-hygro transmitter can be placed onto any flat surface or wall mount using the
bracket which doubles as a stand or wall mount base.
To wall mount:
1.
Secure the bracket onto a desired wall using the screws and plastic anchors.
2.
Clip the transmitter onto the bracket.
Note:
Before permanently fixing the thermo-hygro to the wall base, pace all units in the
desired locations to check that the outdoor temperature and humidity readings are receivable. In
event that the signal is not received, relocate the thermo-hygro transmitter or the weather station
slightly as this may help the signal reception.
